XBP9X-DMUS-021
Digi XBP9X-DMUS-021, XBee-PRO SX 900
Digi XBP9X-DMUS-021, XBee-PRO SX 900, 1W, DigiMesh/Point to Multipoint, SMT, U.FL, Australia
|
XBP9X-DMUS-021
|
|
| Performance | |
| Frequency Range |
ISM 902 to 928 MHz |
| Transmit Power (Software Selectable) |
Up to 30 dBm* |
| Channels |
10 hopping sequences share 50 frequencies |
| RF Data Rate |
Low data rate: 10 kb/s; Middle data rate: 110 kb/s; High data rate: 250 kb/s |
|
Maximum Data Throughput |
High data rate: 120 kb/s |
| Available Channel Frequencies |
Low and middle data rate: 101**; High data rate: 50 |
|
Receiver Sensitivity |
Low data rate: -113 dBm; Middle data rate: -106 dBm; High data rate: -103 dBm |
| Reciver IF Selectivity |
Low data rate, +/- 250 kHz: 40 dB; Low data rate, +/- 500 kHz: 50 dB Middle data rate, +/- 250 kHz: 30 dB; Middle data rate, +/- 500 kHz: 40 dB High data rate, +/- 500 kHz: 30 dB; High data rate, +/- 1000 kHz: 45 dB |
| Reciver RF Selectivity |
Below 900 MHz and above 930 MHz; > 50 dB |
| Rural Range Line of Sight*** |
Low data rate: Up to 105 km (65 mi)***** |
| Urban Range Line of Sight**** |
Low data rate: Up to 18 km (11 mi)***** |
|
Indoor Range***** |
Low data rate: Up to 300 m (1,000 feet) |
|
Networking And Security |
|
|
Modulation |
Gaussian Frequency Shift Keying |
| Spreading Technolgoy |
Frequency Hopping Spread Spectrum (FHSS) |
|
Supported Network Topologies (Software Selectable) |
Peer-to-peer (master/slave relationship not required), point-to-point/point-to-multipoint, mesh |
| Encryption |
Optional 256-bit AES CBC encryption. Encryption is enabled with the ATKY command. |
| General | |
|
Dimensions |
3.38 x 2.21 x 1.29 cm (1.33 x 0.87 x 0.12 in) |
|
Weight |
3 g |
| ROHS |
Compliant |
| Manufacturing |
ISO 9001:2000 registered standards |
| Host Interface Connector |
37 castellated SMT pads |
| Antenna Connector Options |
U.FL or RF pad |
| Antenna Impedance |
50 ohms unbalanced |
| Maximum Input RF Level AT Antenna Port |
6 dBm |
| Operating Temperature |
-40° C to 85° C (-40° F to 185° F) |
|
Power Requirements |
|
| Supply Voltage | 2.6 to 3.6 VDC, 3.3 V typical |
| Receive Current | 40 mA |
|
Transmit Current |
900 mA @ 30 dBm; 640 mA @ 27 dBm; 330 mA @ 20 dBm |
| Sleep Current | 2.5 uA |
| Regulatory Approvals | |
|
United States |
FCC ID: MCQ-XBPSX |
| Canada |
IC: 1846A-XBPSX |
| Australia | RCM |
